OBD2 Car ScannerWhat does U1133 mean?
U1133 stands for SCP (J1850) Invalid or Missing Data for Vehicle Motion. Two or more of the car's computer modules are not communicating properly over the vehicle network (CAN bus).
Network codes cover the communication between the car's computer modules. When the car's computer sees a reading outside its normal range, it stores this code and may turn on a warning light on the dashboard.
Common causes
- Low or weak battery
- Damaged network wiring or connector
- A module that has lost power or failed
- Aftermarket accessories interfering with the network
What to do
- Read all stored and pending codes with a scanner. Several codes together often point to one cause.
- Note the freeze frame data (speed, temperature, load) recorded when the code was set.
- Inspect the wiring and connectors of the part named in the code for damage, corrosion or looseness.
- Fix the most likely and cheapest cause first, then clear the code and drive to see if it comes back.
Read this code from your own car
Plug in a cheap ELM327 adapter and the app shows every fault code, what it means and how to fix it.
Frequently asked questions
What does U1133 mean?
U1133 means “SCP (J1850) Invalid or Missing Data for Vehicle Motion”. It belongs to the network communication group: Two or more of the car's computer modules are not communicating properly over the vehicle network (CAN bus).
Is it safe to drive with U1133?
You can usually drive carefully for a short time, but fix it soon to avoid further damage or higher fuel use.
How do I clear U1133?
Fix the cause, then clear the code with an OBD2 scanner or app. If the fault is still there, the code will come back.
Related codes
- U1129SCP (J1850) Invalid or Missing Data for Primary Id
- U1130SCP (J1850) Invalid or Missing Data for Fuel System
- U1131SCP (J1850) Invalid or Missing Data for Fuel System
- U1132SCP (J1850) Invalid or Missing Data for Vehicle Motion
- U1134SCP (J1850) Invalid or Missing Data for Ignition Switch / Starter
- U1135SCP (J1850) Invalid or Missing Data for Ignition Switch / Starter
- U1136SCP (J1850) Invalid or Missing Data for Telltales
- U1137SCP (J1850) Invalid or Missing Data for Telltales
Code meanings can vary by manufacturer. This page is general guidance, not a repair manual. Always confirm the cause before replacing parts.